Cup Holders

[Sirkid]

Hi, any recommendations for cup holders? I've seen a few 3D print options but just wondering if anyone has experience with any they would recommend. I'm heading to the Nurburgring in September so need somewhere for my coffee on those french motorways! Thanks in advance. Rory

[kdevitt]

I bought one of the 3D printed ones which replace the ashtray. Actually worked fine - didn’t interfere with the gear lever. Problem with the design / my ashtray light - meant I was getting light coming out the bottom of it at night when it was pushed in fully. This bugged me more than I should have - I probably could have removed the bulb, but just put the ashtray back instead!!

[Sirkid]

Thanks Keith. I might give one of them a try so.