|
|
#1
03-10-2007, 05:49 PM
|
|||
|
|||
VTec bushing Q
Can anybody help this guy out, i'm not familiar with the vt suspension setup and what’s different. Is an EE8 the european version?
Thanks, Mark. "Hi,i need your help,i have a crx 91 v-tec EE8 and i want to buy bushings,i have find the hyperflex master set but is for crx 91 U.S.A and i think don't fit some of it,you know the defferences and which bushings is for my car?"
__________________
Mark McCandless JDM CR-X Resource www.cr-x.org 
|
|
#2
03-10-2007, 07:20 PM
|
|||
|
|||
|
EE8 is the VT code.
As for differences, if he were to get the full kit for a 91 USDM Si he will need to piece together extra bushings. Namely: Complete Master Bushing Set 16.18102 Plus required bushes for VT Strut rod kit from Integra: 16.7104 Transmission shifter stabilizer set for 84-87 CRX 16.1101 Lower control arm pivot busing for Integra: 16.3109 (Note: here I think 16.3104 will work but not postive on this as i dont have a vt and cant verify it, if it does it is included in the main kit so wont need 16.3109) I'd also recommend getting the following which arent included in the kit. 16.5110 18mm Front sway bar 16.5112 15mm Rear sway bar 16.7106 Rear Trailing Arm Bush Note: 16.3104 - 89-91 UKDM (Fork)rear lower control arm 16.3111 - 88 + JDM (loop&eye) rear lower control arm 16.3109 - Integra rear (This is used by some on crx uk!!) He can buy the kit off billb on crx uk or go onto http://www.suspension.com/civic.htm and piece it together himself for slightly less, There is a uk kit on the site so maybe ask them what past buyers with VTs went for, they cant verify it themselves but perhaps customers have told them what works and that way he wont have bits left over. I have dealt with them in the past and they are very helpful with quick shipping. Depends where hes from really though, if hes uk id say go for billb. He will have bits left over from the main kit if he does it himself. I dont have a vt so never really needed to look into it, all that concerned me when fitting the kit was the rear lower contol arms for my JDM Si.
__________________
89 Black JDM CR-X Si (You might call it a project) 91 Gunmetal Grey UKDM CR-X 16v 98 Passion Orange UKDM Civic VTi MB6 90 White USDM CRX HF (JDM B20B Swap) 05 White USDM Subaru Legacy Outback
|
|
#4
03-11-2007, 02:27 PM
|
|||
|
|||
|
I just realised you have most of that on the main page lol, damn it took a while to write that [|)]
__________________
89 Black JDM CR-X Si (You might call it a project) 91 Gunmetal Grey UKDM CR-X 16v 98 Passion Orange UKDM Civic VTi MB6 90 White USDM CRX HF (JDM B20B Swap) 05 White USDM Subaru Legacy Outback
|
|
#6
03-12-2007, 01:40 AM
|
|||
|
|||
|
Aren't you the guy that forgot this forum was here, too?
__________________
Black 92 JDM 1.5X....R.I.P. White 91 Irish 16V...SOLD Black 91 JDM siR.....Re-sprayed and re-upholstered!! Red 90 UK VT Turbo...Stolen [  ]
|
|
#7
03-12-2007, 08:02 AM
|
|||
|
|||
|
Yeah thats true, i'm the worlds worst forum admin. Think of me as an absentee landlord with alzheimers, rents free because i'll keep forgetting your here
 Mark. P.S. Just noticed how pathetic my post count is!
__________________
Mark McCandless JDM CR-X Resource www.cr-x.org
|
|
#8
03-14-2007, 12:32 PM
|
|||
|
|||
|
Well, you don't have a CRX any more (I think?) so that's some excuse at least.
__________________
Black 92 JDM 1.5X....R.I.P. White 91 Irish 16V...SOLD Black 91 JDM siR.....Re-sprayed and re-upholstered!! Red 90 UK VT Turbo...Stolen [ ]
|
|
#9
03-14-2007, 02:05 PM
|
|||
|
|||
|
Sort of do, my 1.5x is sitting outside my sisters house looking sorry for itself. Havent driven a rex in years though, must be 4 years at least [:0]
__________________
Mark McCandless JDM CR-X Resource www.cr-x.org
|
 |
|
|
Linear Mode
