7j x 15 ET13 4X100

BEECEE · #1 02-21-2008, 09:15 PM

could the above wheel fit a crx .

C-Rex · #2 02-21-2008, 10:21 PM

Everything but the offset is ok that could be fecking it up a bit..
Normal offset is ET38 Im not sure how this will effect the handeling

sszaki · #3 02-22-2008, 06:34 AM

ET is shite for crx vtec should be 40-50, 13 will be horrible

BEECEE · #4 02-22-2008, 09:19 AM

ok cheers .

Cyclonium · #5 02-22-2008, 03:34 PM

Talk to chief on crx uk, he had a serious dish on his and i think the offset was pretty low.

BEECEE · #6 03-29-2008, 07:18 PM

can someone explain offset to me , in lay mans terms , i hoping to get some work equip 03s and the more i read the more confused i get [?], tyre stretching and the like , cheers .

C-Rex · #7 03-30-2008, 04:25 PM

Where you looking at getting the 03s from[8D]

C-Rex · #8 03-30-2008, 04:29 PM

Offset is basically how far the wheel stick in or out in the arches..

The width of the wheel may be 7inches.
If the spokes are on the outside of the rim the wheel will be 7inches in under the arch..
If the spokes are on the inside of the rim the wheel will be 7inches outside the arch...

Kinda the basic idea of offset

BEECEE · #9 03-30-2008, 06:10 PM

ok i still dont get it , using the above wheel size 7j x 15 et13 . with is 7" , diamater is 15" what is the et13 bit ? when people say a wheel will rub because of the ofsett , but the wheel is still only 7" ?

03s from the states , hope to get them for around $300 each delivered , with the dollar rate so good and still falling , you would be mad not to .i got the koni yellows , eibach springs and the ground control coilovers for 690 euro including post and bank charges for transactions , now i just hope mr customs is nice ..

BEECEE · #10 03-30-2008, 07:02 PM

thanks for the help , just found this making a bit more sense .
http://www.driverstechnology.co.uk/wheel-offset.htm