#1
|
|||
|
|||
Prelude Front Calipers
2.2 VTI Front Calipers c/w carriers same spec as 98+ ITR for a fraction of the cost. Bolt on upgrade for VTEC's (you may need to give the carriers a rub with a grinder) you will need vtec huts & tre's for a 1.5 of 16v which I may have @ an addtional cost
€100 [u]Note.</u> 1. You will need to get 282mm discs for these. Either redrill Prelude / ITR discs to 4x100 or get MGZR discs which are already 4x100 2. You will need 15's to clear these
__________________
ZC Hoarder |
#2
|
|||
|
|||
how much you looking for the hubs ands tre's?
|
#3
|
|||
|
|||
I have a set but one of the studs is sheared so it means you would have to get the bub pulled which is a pain in the ass. I might have another set by the weekend. Id be looking for about €50 a side if i was selling a good set. The set I have id let go for €50 due to having to get the hub pulled & the stud replaced. All prices are ono of course
__________________
ZC Hoarder |
#4
|
|||
|
|||
is there tre's with the bad hubs and if so what condition are they and the bearrings in? would it just have to be pressed apart to remove the stud? could you post up a pic of the hubs, i think im going to waterford at the weekend would you be around i might be able to collect them if im able to replace the stud
|
#5
|
|||
|
|||
Tre's are with the hubs seem in good condition ill double chack & come back toyou. You will have to press the hub off its too tight to get the stud out. Is it the calipers & hubs or just the hubs you want
__________________
ZC Hoarder |
#6
|
|||
|
|||
hubs for the moment anyway
|
|
|