I-vt Project

[C-Rex]

Two screw in the arches (like what I showed you on the front bumper) and think there is 2/4 10mm nuts going into the boot from the back.. That should get the bumper off.. Just keep ripping

[Dohctor]

Got it off

Now to add those black stripes today hopefully.

Wanna paint the rocker today too, do i just bolt it off or is there anything I should be aware off?

[skipmcauliffe]

Just bolts off very easily, just make sure you dont lose the seal for putting it back on

[Dohctor]

A little update, havent done much tbh waiting on a call for some screws to throw on the front bumper correctly and get it inline and a passenger side front quarter panel for I can get the side lamp properly attached. Small but annoying work lol.

Cleared the boot too, let it dry in the sun and then tried to source the leaking, hoping it was the washer but it wasnt so thats a b-a-l-l-s.

Can anyone throw on lowering springs btw? If anyone could it would be great and obviously I would pay ya for it!

[djchickcrx]

leak is probably either from the gaskets on the rear lights or else from the sunroof drain tubes, which run down the qater panels

[Dohctor]

^Actually that could be it, the seals are a popped up out of place a little.

[h22crx]

ill stick them on for ya but im a nice bit away

[Dohctor]

^Ya it really wouldnt be worth your timr coming down sickning

On the plus side, got all the parts now and have them ready to fit so hopefully the the front should be looking good once i have them thrown on tomoro

Also, have nearly all the screws of the wing panal off but I cant seem to get the last 2 which are between the door and arch on the bottom. Anyone?

[djchickcrx]

jam an allen key in the back of the required socket. its thin enought then to fit into the gap to get at those bolts. just mask off the door.wing around it or else you'l end up taking paint off

[Dohctor]

Ok man will give that a shot, hopefully it will work now!