I-vt Project - Page 5

Dohctor · #41 04-01-2009, 04:25 PM

k threw on the bumper to my best ability today and for some reason it isnt fitting the drivers side properly no matter what I do (Unless Im somehow doing it wrong?)

I have pictures to show ya anyay, and nevermind the splitter, didnt get to put it on properly.

where it wont fit on.

h22crx · #42 04-01-2009, 05:48 PM

^^^ how much did the slicks cost !!!!!

it looks like its almost there just pust it over the plastic piece thats on the wing. that plastic mount also moves forward and back for adjustment

dotswilliams · #43 04-01-2009, 06:14 PM

fit the bumper to the wings first and then fit the screws in the middle

Dohctor · #44 04-01-2009, 10:11 PM

I tried to get it over that bit, it just wouldnt budge. and for some reason when its up more the center screws dont allign up.

dotswilliams · #45 04-02-2009, 07:15 PM

are you living in dublin mate it sez ireland on your profile

djchickcrx · #46 04-02-2009, 07:34 PM

see that offwhite plastic yoke on the very edge of the bumper, well that has a bolt that goes through the wing onto the bumper, and that usually pulls it all together, only thing is, it looks your headlights may be off a bit, could the T-bar for the bumper be slightly off. Wouldnt be difficult to replace

Dohctor · #47 04-02-2009, 08:17 PM

Dotswilliams - Living in North Kerry

Ya I didnt notice the lights, Hmm how much would the T-bar set me back?

djchickcrx · #48 04-02-2009, 11:16 PM

theres definate front end damage under the rad in this photo.Did the bumper t-bar look out to you. I wouldnt get too worried anyways, if it needs replacing im sure you'll get it for next to nothing on crx-uk.
the wings looks good anyways, keep at it, it may just fit together eventually.

skipmcauliffe · #49 04-02-2009, 11:27 PM

There is def front end damage on it,had the same on my old 1.5x, although i did hit a bus with it[:I] that t-bar wont cost you much at all, get on to the fella you got the bumper and things off of in Drogheda, i'd say he will give you the parts you need for nxt to nothing, wont cost you much to get it straightened up nd fitting well! If you need any help, i'm not far away from you at all, I might not be an expert but I can be an extra set of hands, have plenty of time on my hands at the moment

Dohctor · #50 04-03-2009, 02:07 PM

cheers for that lads [^] will get looking for a T-bar asap