#1
|
|||
|
|||
driveshaft problem maybe???
Hey all,
I'm sure this has been covered here many times but i did a search and couldn't really find anything... Anyway I have a 91 CR-X SiR and I'm getting a thumping noise and vibration at say 100 km/h onwards. Only really happens under acceleration. It's not wheel balancing (I wish) and I had it inspected by the tuning factory guys about 10 months ago and they found nothing really. One of the shafts was slightly bent but not enough to cause a problem they reckon. It's also intermittent. can go for months with no problem and then back for a while, car is used daily 500 kms a week and the odd trackday I'm not that mechanically gifted so any help or advice is greatly appreciated. thanks[^] |
#2
|
|||
|
|||
Check the inner CV joint the bearings are known to collapse in these happened to my CRX years ago and Stephen K just found them gone in his last week. Its the exact symptoms mine had.
__________________
Paul 91 Torino Red EF8 90 Torino Red EF6 |
#3
|
|||
|
|||
Brilliant, thanks! I'll get it checked when I get a chance.
|
#4
|
|||
|
|||
Ya, inner bearings.
Is the car lowered a lot?? That's what kills them, as they allow for different lengths of the drive shafts, as suspension travels upwards and downwards. Lowering the suspension, does not directly cause them to fail, but soft dampers, usually stock, contribute to failure also.
__________________
0851655770 For all your Honda problems |
#5
|
|||
|
|||
Nope not lowered, pretty original standard car. Looked like a monster truck parked beside stephen k's crx at a trackday last year.
|
#6
|
|||
|
|||
If it is the bearings ones off an EK vti will fit onto your trident thingy, i done mine a few weeks back.
|
#7
|
|||
|
|||
Thanks for all the replies lads.
What baffles me is the way it comes and goes. Tramped all the way to work this afternoon and then coming back tonight it was very smooth at all speeds even driven hard! |
#8
|
|||
|
|||
They do that.
__________________
0851655770 For all your Honda problems |
#9
|
|||
|
|||
Apologies for all the questions...
Where would you guys go for the relevant parts? Honda? Internet? And if anyone has any recommendations for someone to do the work that would be cool. I'm based in Dubland. |
#10
|
|||
|
|||
Hard to say first off get it checked that its definitely the inner CV joint. If it is then they are very hard to get new from Honda is crazy money you could possibly get them online though. Can't check at the minute off my phone but try get them new anyway so its done right
__________________
Paul 91 Torino Red EF8 90 Torino Red EF6 |
|
|