#1
|
|||
|
|||
Koyo Racing radiator
has any body installed a koyo racing rad with out doing any Mods? if you did do a mod what did it take to make it fit?all help would be greatly helpfull...doing this mod to a 91 CR-X SI
__________________
A.C.U.R.A = ALL CARS UNDER RECALL AGAIN. |
#2
|
|||
|
|||
Depends on which one you mean.
1.) There is a direct replacement which will fir fine in a Si (There are mods needed if fitting to a vt/sir) 2.) Half size rad from a eg civic. I will be fitting this due to space restrictions, if fitting with front stock x-member you will have to lean it back to clear the hood afaik. I will be using it with a full-race traction bar so hopefully wont need to do this
__________________
89 Black JDM CR-X Si (You might call it a project) 91 Gunmetal Grey UKDM CR-X 16v 98 Passion Orange UKDM Civic VTi MB6 90 White USDM CRX HF (JDM B20B Swap) 05 White USDM Subaru Legacy Outback |
#3
|
|||
|
|||
im using the stock front crossmember.
__________________
A.C.U.R.A = ALL CARS UNDER RECALL AGAIN. |
#4
|
|||
|
|||
If you use the crx specific you will be ok.
If you are using the 92-00 civic, half size you will most likely need a lean. You may get away with it if your car is a facelift jdm si, im not sure. 92-00 half size, one im using, install pics have still a while to go Out of interest why are you putting one in, they are mega money tbh. Oh and welcome to the forum [8D]
__________________
89 Black JDM CR-X Si (You might call it a project) 91 Gunmetal Grey UKDM CR-X 16v 98 Passion Orange UKDM Civic VTi MB6 90 White USDM CRX HF (JDM B20B Swap) 05 White USDM Subaru Legacy Outback |
|
|